Kenwood dealer. • If the unit does not seem to be working right, try pressing the reset button first. If that does not solve the problem, consult your Kenwood dealer. (AWG18) or more to prevent wire 7.0-inch WIDE COLOR LCD MONITOR...
Operation V.SEL MODE SCRN Power Turning on the power Press the V.SEL button. Turning off the power Press the V.SEL button for at least two seconds. Switching the Screen Mode Each time you press the MODE button, the screen mode switches as follows: ∞...
• If you make no key operation for 10 seconds, the picture quality adjustment screen is automatically cancelled. Setting the Remote Sensor On/Off If this unit also runs when operating other units with different Kenwood remote controls, its remote control function can be turned off. Press the SCRN button for at least two seconds, the function setup screen to be displayed.
Installation Accessories External view ... Number of items Installation Procedure 1. To prevent short circuits, remove the key from the ignition and disconnect the · terminal of the battery. 2. Make the proper input and output cable connections for each unit. 3.
Page 7
• Be sure to use the supplied screws for installation. Using screws longer than those supplied may destroy parts inside the unit causing it to smoke. Using screws shorter than those supplied may cause the unit to come looks from the installation bracket. •...
Installation Installation for Monitor Unit Installation location and cleaning Select for installation a location where the stand can be placed completely horizontal or where the front edge of the support (petal-shaped part) can be attached horizontally as shown in Figure A. Do not install in locations where the entire support is at a diagonal such as in Figure B or where the monitor unit is facing down such as in Figure C.
Connection Monitor Unit Accessory 2 Video Box Unit POWER VIDEO VIDEO UNIT MONITOR Accessory 1 +12 V Video input Video Output 2 CAUTION For the sake of safety, be sure to connect the parking sensor. PRK SW Parking sensor cable (Green) Ignition key switch Fuse (5A) Ignition cable (Red) ª12V...
Troubleshooting Guide What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. PROBLEM The power does not turn on. Nothing happens when the buttons are pressed.
Specifications Specifications subject to change without notice. Monitor Unit Screen size ...7.0 inches wide Display system ...Transparent TN LCD panel Drive system ...TFT active matrix system Number of pixels ...336.960 pixels (480 H x 234 V x RGB) Effective pixels ...99.99% Pixel arrangement ...RGB striped arrangement Back lighting ...Cold cathode tube Video Box Unit...