Kenwood LZ-651W Instruction Manual
Kenwood LZ-651W Instruction Manual

Kenwood LZ-651W Instruction Manual

Wide screen monitor
Hide thumbs Also See for LZ-651W:

Advertisement

Quick Links

WIDE SCREEN MONITOR
LZ-651W

INSTRUCTION MANUAL

Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you obtain the best
performance from your new LZ-651W.
For your records
Record the serial number, found on the back of the unit, in the spaces designated on
the warranty card, and in the space provided below. Refer to the model and serial
numbers whenever you call upon your KENWOOD dealer for information or service on
the product.
Model
Serial number
© PRINTED IN JAPAN B64-2631-00/00 (E/K)

Advertisement

Table of Contents
loading

Summary of Contents for Kenwood LZ-651W

  • Page 1: Instruction Manual

    Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your KENWOOD dealer for information or service on the product.
  • Page 2: Before Use

    • Keep a cellular phone or other things that oscillate high frequency away from this unit. If not, the picture of the monitor may be distorted or noises may occur. NOTE If you experience problems during installation, consult your Kenwood dealer. If the remote control should become unresponsive, replace with new batteries (i.e., 2 x R03).
  • Page 3 • Volume 1 Mode Setting switch Selects the target device to control. MON: Monitor control mode NAVI: Navigation system control mode AUD: Kenwood car audio system control mode 2 Volume Control button 3 Power button 4 Cursor button Selects the item when the menu screen is displayed.
  • Page 4: Setup Menu

    Setup Menu Setting Menu Screen control 4 English MENU Press button. MENU Menu screen is displayed, and the monitor enters to menu mode. Press button to select the adjusting item, ENTER and press button. VOICE "SCREEN CONTROL": Adjust the picture quality (brightness, contrast etc.).
  • Page 5 "NAV": Setup input and switch method of the navigation picture. Item Setting "RGB"* When Kenwood navigation system is connected by the dedicated cable. "AV-IN" When connected to AV-IN terminal be composite signal cable. "OFF"...
  • Page 6: Installation Procedure

    Installation Accessories Installation Procedure 1. To prevent short circuits, remove the key from the ignition and disconnect the · terminal of the battery. 2. Make the proper input and output cable connections for each unit. 3. Connect the wiring harness cables in the following order: ground, ignition.
  • Page 7 Connection Monitor Unit Navigation Unit Cable accompanying the Navigation System NAVI Ignition key switch Battery AV input AV cable (Commercially available) Bundle cables with the clamper (Accessory A) Mute cable (Brown) Fuse (2A) Connect TEL mute cable of the navigation system. Ignition cable (Red) 2CAUTION...
  • Page 8: Installation For Monitor Unit

    Installation Installation for Monitor Unit Installation location and cleaning Select for installation a location where the stand can be placed completely horizontal or where the front edge of the support (petal-shaped part) can be attached horizontally as shown in Figure A. Do not install in locations where the entire support is at a diagonal such as in Figure B or where the monitor unit is facing down such as in Figure C.
  • Page 9: Troubleshooting

    Troubleshooting What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. The power does not turn on. • The fuse has blown. •...
  • Page 10 FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

Table of Contents