Table of Contents
Advertisement
A
T
IR S
E
DDING
HE
IGNAL
XTENSION
Also included with the remote package is an IR Signal Extension Cord for
use with a home entertainment device that is not in direct line-of-sight of
the IR/RF Command Center.
If you are having problems remotely controlling a home entertainment
device from another room, try performing the following installation:
1.
Plug the 4-foot IR Signal Extension Cord into the back of the
IR/RF Command Center.
2.
Run the IR Signal Extension Cord to the device that is not in
line-of-sight of the IR/RF Command Center.
3.
Using the supplied double-sided tape, attach the IR Signal
Extension Cord so that its LED is over or next to the IR sensor
of your home entertainment device.
4.
Test the installation by again taking the remote into another
room in your home, up to 100 feet away. Select a device key
(e.g., TV) and press it once. Then press POWER once.
The IR/RF Command Center will convert the RF signal
from the remote into an IR signal and transmit that signal
through the IR Signal Extension Cord to turn on your device
(e.g., TV).
If it does not turn on, try repositioning the LED until the
device can be controlled, then re-attach the LED.
C
ORD
LED
O
IR/RF C
PTIMIZING
OMMAND
To optimize the operation of your IR/RF Command Center, try
the following:
•
Aim the remote toward the room where the IR/RF Command Center
is located.
•
Do not position the IR/RF Command Center near metal objects, such
as heat ducts. Metal can absorb RF signals.
•
Make sure the batteries in the remote are fully charged. Try replacing
them if you are not sure (see Installing Batteries on page 3). Weak bat-
teries will affect the signal range.
•
Make sure that the remote is not being affected by other RF transmis-
sions (e.g., garage door openers, cordless telephones, etc.).
NOTE: The tests for range limits of the remote and the IR/RF Command Center
were conducted in open-air distance tests. Actual signal distance will be based on
the construction of the building the unit is being used in, as well as other factors,
such as outside interference.
SPECIFICATIONS
Remote Control Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 AAA Batteries
IR/RF Console Power. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 Vac
Remote Control to IR/RF Console Range . . . . . . . . . . . . . . 100 Feet (30.48 m)
IR/RF Command Console to Device Range . . . . . . . . . 25 Feet (7.62 m) ± 30˚
Remote Control Dimensions
(H x W x D). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9.21 x 2.52 x 1.34 in.
(H x W x D). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 234 x 64 x 34 mm
IR/RF Command Console Dimensions
(H x W x D) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-9⁄16 x 5-1⁄16 x 4 in
(H x W x D) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39.7 x 128.6 x 101.6 mm
Remote Control Weight (without Batteries) . . . . . . . . . . . . . . . . 0.45 lb (204 g)
IR/RF Command Console Weight . . . . . . . . . . . . . . . . . . . . . . . . 10.4 oz (300 g)
NOTE: Specifications are typical. Individual units might vary. Specifications are
subject to change and improvement without notice.
Using The IR/RF Command Center/Specifications 21
U
'
G
SER
S
C
R
ENTER
ECEPTION
UIDE
Hide quick links:
Advertisement
Table of Contents
