Using Keymover; Programming Keymover; Restoring A Single Keymoved Key; Restoring All Keymoved Keys In A Single Mode - Radio Shack 8-IN-ONE REMOTE Owner's Manual

USING KEYMOVER

The remote includes a Keymover feature that allows you to map
(or copy) keys from one mode (i.e., source mode) to another mode (i.e.,
destination mode).
NOTE: The following keys cannot be used as a source or destination: VCR, CBL, SAT,
TV, CD, AUX, DVD, MY SYSTEM, AUDIO, and P.
P K
ROGRAMMING EYMOVER
For example, if your VCR does not have volume control, try mapping the
volume and mute keys from TV mode to VCR mode as follows:
1. On the remote, press and hold P until the display changes
from the default device and time to [CODE SET].
NOTE: Default values for device, its code, and time are shown
above.Your remote control settings may be different.
NOTE: If you wish to exit the programming mode at any time, press
EXIT once. An [EXIT] message appears as the remote control returns
to normal operation.
NOTE: If an [INVALID] message appears, you have inadvertently
pressed an incorrect key. Simply note your error and continue
programming.
L
2. Press five times until [KEYMOVER] appears.
(x 5)
NOTE: If you go past [KEYMOVER], press
return to it.
3. Press SELECT once to begin programming. [FROM MODE]
appears.
4. Select a source mode (e.g., TV) and press it once. [FROM KEY]
appears.
5. Select a source key (e.g., VOL+) and press it once. [TO MODE]
appears.
6. Select a destination mode (e.g., VCR) and press it once.
[TO KEY] appears.
7.
8.
Upon completion of the above procedure, you can now use your remote
to control the TV's volume and mute in the VCR mode, as well as in the
TV mode.
R
ESTORING
1.
2.
M
one or more times to
R
ESTORING
1.
2.
Select a destination key (e.g., VOL+) and press it once.
[SUCCESS] appears, followed by [EXIT SETUP]. The remote
will automatically exit the programming mode and return to
normal operation.
Repeat steps 1 through 7 twice more, substituting VOL– and
MUTE as source and destination keys in steps 5 and 7.
A S K K
INGLE EYMOVED EY
Perform steps 1 through 7 of the previous section,
Programming Keymover. However, this time in step 6, make
the destination mode the same as the source mode (e.g., TV).
[CLR KMVR] appears.
Press SELECT once to clear the keymoved key. [DELETED]
appears, followed by [EXIT SETUP]. The remote will
automatically exit the programming mode and return to
normal operation.
A K K I A S
LL EYMOVED EYS N INGLE
Perform steps 1 through 4 of the earlier section,
Programming Keymover. However, this time in steps 3 and 4,
make the source mode and source key the same mode (e.g.,
TV). [CLR KMVR] appears.
Press SELECT once to clear all keymoved keys from this
mode. [DELETED] appears, followed by [EXIT SETUP]. The
remote will automatically exit the programming mode and
return to normal operation.
U ' G
SER S UIDE
M
ODE
Using Keymover 15