Reference Tables: Configuration Parameter Modules; Configure Module 1 - Input Parameters (1-In) Cn63100 - Omega CN63100 Series User Manual

REFERENCE TABLES: CONFIGURATION PARAMETER MODULES

Configure Module 1 - Input Parameters (1-IN) CN63100

These tables are only used for programming the CN63100 models.
Use the tables on page 21 if you are programming a CN63300.
Range and Units
Display Parameter
(Factory Setting)
tYPE Input Type tc-t - Type T TC
tc-E - Type E TC
tc-J - Type J TC
tc-k - Type K TC
tc-r - Type R TC
tc-S - Type S TC
tc-b - Type B TC
tc-N - Type N TC
LIN - Linear mV display
r385 - 385 curve RTD
r392 - 392 curve RTD
rLIN - Linear ohms display
(tc-J)
SCAL Temperature °F/°C
Scale (°F)
dCPt Temperature 0 or 0.0
Resolution (0)
FLtr Digital Input 0 to 4
Filtering And (1)
Display
Update
Description/
Comments
Thermocouple select
RTD select
If scale is changed,
be sure to check all
parameters.
If resolution changed,
be sure to check all
parameters.
Increase number for
more filtering effect.
4 = 500 msec display
update rate. Adjusted
* Model Number Dependent
by Auto-Tune.
-20-
Display Parameter
SHFt Input Signal -999 to 9999
Shift (correction 1 or 0.1 degree
offset) (0)
SPLO Setpoint Lower -999 to 9999
Limit 0 or 0.1 degree
(0)
SPHI Setpoint Upper -999 to 9999
Limit 1 or 0.1 degree
(9999)
SPrP Setpoint Ramp 0.0 to 999.9 degrees/minute
Rate (0.0)
InPt User Input * PLOC - Program disable
ILOC - Integral action on/off
trnF - Auto/manual select
SPrP - Setpoint ramp on/off
ALrS - Reset alarm output(s)
SP2 - Select SP1/SP2
rSP - Select
PrNt - Serial block print
(PLOC)
Range and Units Description/
(Factory Setting) Comments
Normally set to 0.
Set low limit
below high limit.
Set high limit
above low limit.
0.0 is off (no
ramping)
Low = lock
Low = off
Low = manual
Low = end ramp
Low = reset
Low = SP2
Low =remote
Local/Remote
Low =block print