Star Trac E-TRe Troubleshooting Manual page 32

Power the computer by attaching it back into the unit and turning on the power or using an external power source (12
4.
VDC)
5. Momentarily short the two pins on the jumper header as shown in the pictures below using a flat head screwdriver.
The computer will turn on. After a few seconds the computer will beep once.
6.
Turn off the power to the unit.
7.
Turn on the power to the unit and after a few seconds the computer should power on.
8.
Steps 7 and 8 can be repeated and each time the computer should power on.
9.
10. Once this is done, replace the metal box on the computer and re-assemble the unit.
11. Power up the unit and run a workout to ensure proper function.
STAR TRAC FITNESS
Troubleshooting
Fig. 3
4 of 4 637-1382 Rev: A