Flowchart - Star Trac E-TRe Troubleshooting Manual

Verify that the
treadmill plugged
into the wall and
the power switch is
set to the 'on'
position?
Is there
sufficient
voltage from
the wall?
No
Yes
Turn the breaker
on so power is
coming from the
outlet and test the
treadmill.
Disconnect the power cord from the
underside of the treadmill and
reconnect it. Also verify that the cord is
secured with the tie strap.
(See 637-1308)
Treadmill is
operational.
Pg. 2
Ver 1
Ver. 1
Unit plugged in and
No
power switch on?
Yes
Verify that there
is power coming
from the wall.
Either 110 VAC
or 220 VAC
Check the wall
breaker. Make
sure the breaker
has not tripped
off..
Yes
Does the
Yes
screen turn on?
No
Does the
Yes
screen turn on?
Version 1 or
Version 2
Ver 2
Pg. 2
Ver. 2
Plug the treadmill
into the wall outlet
and turn the power
switch to the 'on'
position and test.
No
Was the
breaker tripped No
off?
Treadmill is
operational.
Yes
Does the
No
screen turn on?
Push the
breaker in to
Yes
reset and test
the unit.
No
Determine the
version of the MCB
Yes
inside the treadmill.
(See 637-1338)
Does the
Yes
screen turn on?
The outlet is at fault. Plug the
treadmill into another outlet.
Verify that the
breaker on the
treadmill has not
been tripped.
Was the
breaker
tripped?
No
Remove the motor
shroud. Check the
MCB to see if any
lights are on.
Are the MCB getting power or is faulty.
No
lights on?
"MCB Will Not Power Up"
Treadmill is
operational.
The MCB may not be
Follow the procedures in
MCB Will Not
Power Up
(637-1378)