Attachment Of Presser Foot Lifter; Attachment Of Pf Switch Assy - Brother CE-5500PRW Service Manual

Application of Assembly
9

Attachment of Presser foot lifter

1. Set the presser foot lifter 1 to the shaft 2 of the base holder assy., and
then attach the retaining ring E4.
*Key point
• Push the presser bar clamp 3 to the upper side, and then
attach it while pushing the bottom side of the thread release
lever 4.
Apply EPNOC AP (N) 0 to the shaft of the base
holder assy.
Apply EPNOC AP (N) 0 to the operating surface of
the presser bar lifter presser bar clamp.
10

Attachment of PF switch assy

1. Set the PF switch assy. 1 to the presser switch holder 2.
*Key point
• Check that the boss part of the PF switch assy. 1 align the
positioning hole of the presser switch holder 2.
2. Set the presser switch holder 2 to the base holder assy. with the screw 1.
*Key point
• Check that the boss part of the PF switch assy. 1 align the
notch part of the base holder assy.
1
Needle-presser module
Small amount
Small amount
Screw, Bind
M3X6 0.59 – 0.78 N·m
3
XC8387***
XC8387***
2
2
Torque
Retaining ring E4 1
4
1
2 1
3 - 85