Application of Assembly
12
Attachment of Feed bar
1. Insert the polyester slider 2 and the feed bar 3 into the shaft of the feed
arm A assy. 1, and then attach the retaining ring CS4.
*Key point
• Check that the vertical adjusting screw 4 engaged with the
groove of the vertical lever 5.
• Check that there should no gap between the retaining ring
CS4 and the feed bar 3.
Apply EPNOC AP (N) 0 to the feed shaft hole in
the feed bar.
Apply EPNOC AP (N) 0 to the feed arm A assy.
Apply EPNOC AP (N) 0 to the groove of the
vertical lever.
13
Attachment of Spring
1. Attach the spring
S05
S05
3 - 74
Feed and rotary module
to the feed bar 1 and the base plate assy. 2.
15.2
Retaining ring CS4
Bead
XC8387***
Bead
XC8387***
Small amount
XC8387***
SPRING
XE1940***
1
3
4
5
1
2
S05
2