Alternator Belt - Life Fitness Lifecycle 3500 Series Service Manual

Lifecycle 3500, 4500, 5500 Series Exercise Bikes
How To...REMOVE AND REPLACE THE ALTERNATOR BELT
Tools Required: 1/2" wrench, two 3/4" wrenches
Step 1
Remove the HOUSING (See "How To. . .").
Step 2
With a 1/2" wrench, loosen the ALTERNATOR ADJUSTMENT BOLT.
Step 3
With two 3/4" wrenches, loosen the PIVOT BOLT and LOCKNUT located on the ALTERNATOR.
Step 4
Cup your hand under the worn ALTERNATOR and lift upward. This will relieve the tension from the ALTERNATOR
BELT.
Step 5
With your other hand, slide the ALTERNATOR BELT off the large FREE-WHEEL PULLEY. Loop the
ALTERNATOR BELT around the FLYWHEEL located at the end of the ALTERNATOR SHAFT to remove.
Step 6
Reverse steps 1 through 5 to return all parts back into their proper positions.
Tighten parts to the following specifications:
Free-wheel Gear 35-40 in. lbs.
3