Remote Commands - Radio Shack TAD-724 Owner's Manual

43-724A.fm Page 23 Tuesday, May 16, 2000 4:51 PM
Note: If you pause for 10 seconds between digits, the TAD hangs up.
3. Enter the remote command (see "Remote Commands").
4. When you finish, press

REMOTE COMMANDS

Use these keys on a touch-tone phone or pocket tone dialer to operate the TAD-
724 when you are away from your home or office. Enter your selection within 5 sec-
onds, or the TAD automatically plays back your messages.
Press:
1 Replay the current message.
1 1 Replay the previous message.
2 Play all or new messages.
3 Skip to the next message.
# 3 Change the remote security code. After you hear a beep, enter a
new 3-digit code. The TAD generates another beep to confirm it.
4 Play OGM 1.
5 Play OGM 2.
# 4 Record OGM 1. Enter 0 to finish the recording and the TAD will
play the new OGM 1 for confirmation.
# 5 Record OGM 2. Enter 0 to finish the recording and the TAD will
play the new OGM 2 for confirmation.
# 6 Record memo. Enter 0 to finish the recording.
7 Delete the current message (during playback).
# 7 Delete all messages.
8 Monitor the room where the TAD is installed for 30 seconds.
9 Turn on/off the TAD. If the TAD is on, it beeps twice.
to end remote access.
To:
23