Resetting The Terminal; Soft Reset (Warm Boot); Hard Reset (Cold Boot); Suspend Mode - Honeywell Dolphin 9900 User Manual

Resetting the Terminal

There are two types of system resets: a soft and a hard reset.

Soft Reset (Warm Boot)

A soft reset re-boots the device without losing RAM data. You would perform a soft reset when
• the terminal fails to respond.
• after installing some software applications.
• after making changes to certain system settings, such as network cards.
1. On the 56-key keyboard, press and hold the CTRL
seconds.
On the 43-key keyboard, press and hold the CTRL
seconds.
2. The decode and scan LEDs flash for approximately three seconds as the terminal resets.
3. When the reset is complete, the Today screen displays.

Hard Reset (Cold Boot)

A hard reset resets the operating system, restores the terminal back to factory defaults, and resets the
terminal after a bootloader, keyboard, and kernel upgrade.
A hard reset erases all of the data stored in RAM memory and all RAM installed applications!
1. Press and hold the CTRL
2. The decode and scan LEDs light for approximately 3 seconds.
3. The terminal re-initializes; see

Suspend Mode

The terminal goes into suspend mode automatically when the terminal is inactive for a programmed
period of time. You can program this time on the Advance tab of the Power system setting; see
page 6-12.
To put the terminal into suspend mode manually, press the Power key
To wake the terminal from suspend mode, press the Power
Hardware Maintenance
When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-free
cloth. The terminal can be cleaned with a damp cloth.
Dolphin® 9900 Mobile Computer User's
Guide
SFT
CTRL
+ ESC keys for approximately 5 seconds.
Initialize the Mobile Computer
Rev C
10/30/08
SFT
CTRL
+ SFT keys for approximately 5
CTRL
+ NUM keys for approximately 5
on page 2-8.
and the screen goes blank.
or SCAN keys
Power on
.
3 - 17