Power - Honeywell Dolphin 9900 User Manual

USB Port
This USB Port is full-speed and 2.0 compliant. Using a USB cable, you can connect the base
to a peripheral device, such as a workstation or printer. When the terminal is seated in the
terminal well, it is connected to the peripheral device via the base. The USB port on the base
requires that you use ActiveSync 4.5 or higher.
RS-232 Port
Use a 9-pin, RS-232 cable from Hand Held Products to connect this port to a peripheral device
for RS-232 data communication. For more information, see
DC Power Jack
Use the power cable from Hand Held Products that comes with the base to supply power to
this power jack. For more information, see

Power

The terminal requires 9.5 Volts DC input for communications and battery charging; the power adapter on
the power cable converts the voltage from the power source to 5 volts DC. Only the power adapter cable
from Hand Held Products that comes with the base converts the voltage appropriately.
Honeywell recommends that you leave the base connected to its power source at all times, so that it is
always ready to use.
1. Connect the power cable to the DC jack on the rear panel of the base.
2. Connect the power cable to the power adapter.
3. Plug the power adapter cable into the power source. The base is now powered.
11 - 4
Power on page
Rev C
10/30/08
Serial Connector on page
11-4.
Dolphin® 9900 Mobile Computer
11-5.
User's Guide