Master Arm (Cmd + 1); Description; Using Master Arm - Bosch D1265 User Manual

D1265 | User's Guide | Part II: System Commands

Master Arm (CMD + 1)

Description

Use this function to turn on both the perimeter and
interior of a single area indicated on the first line (top)
of the keypad display. When you turn the system on,
the display shows how many seconds of exit delay time
you have to exit the protected area. You should leave
before exit delay time expires.
Leaving after exit delay has expired causes the entry
delay to start if the person exits through a designated
Entry/Exit door. Exiting through any other point could
cause an immediate alarm. Moving into the interior of
the protected area causes an alarm on an interior
device. If an alarm occurs, enter your personal
passcode to disarm the system.
Your cleaning service, a serviceman, or others might
also use this function to turn on your system when they
leave.

Using Master Arm

Using the CMD+1 command only arms
the area currently displayed on the top
line of the keypad display. For example, if
the keypad is assigned to AREA 1
WAREHOUSE, only AREA 1
WAREHOUSE arms when CMD+1 is
pressed.
1. Ensure your keypad shows idle text.
2. Press the CMD button.
3. The display shows *System Command*.
4. Press the 1 button.
16
5. If your system is programmed to require a
passcode when performing a CMD 1, the
display prompts you to enter your passcode.
The passcode is shown as asterisks (*).
6. If the passcode has valid authority for this
command, the display shows Exit Now! # (# =
exit delay time remaining) seconds remaining.
After the exit delay time expires, the display
changes to idle armed text.
7. To disarm your security system, enter your
personal passcode and press ENTER.
Bosch Security Systems, Inc. | 9/10 | F01U169131-02