Modifying Gvrp Settings - Cisco Linksys SFE1000P Reference Manual

• Interface — Indicates the interface for which the GVRP configuration is displayed.
• GVRP State — Indicates if GVRP is enabled on the interface. The possible field values are:
– Enabled — Enables GVRP on the selected interface.
– Disabled — Disables GVRP on the selected interface.
• Dynamic VLAN Creation — Indicates if Dynamic VLAN creation is enabled on the interface.
The possible field values are:
– Enabled — Enables Dynamic VLAN creation on the interface.
– Disabled — Disables Dynamic VLAN creation on the interface.
• GVRP Registration — Indicates if VLAN registration through GVRP is enabled on the device.
The possible field values are:
– Enabled — Enables GVRP registration on the device.
– Disabled — Disables GVRP registration on the device.

Modifying GVRP Settings

The Edit GVRP Page contains the following fields:
• Interface — Displays the interface on which GVRP is enabled. The possible field values are:
– Port — Indicates the port number on which GVRP is enabled.
– LAG — Indicates the LAG number on which GVRP is enabled.
• GVRP State — Indicates if GVRP is enabled on the interface. The possible field values are:
– Enable — Enables GVRP on the selected interface.
– Disable — Disables GVRP on the selected interface.
• Dynamic VLAN Creation — Indicates if Dynamic VLAN creation is enabled on the interface.
The possible field values are:
Chapter 7: Configuring VLANs
Configuring GVRP Settings
SFE1000P Gigabit Ethernet Switch Administration Guide
Edit GVRP Page
Chapter
7
91