Seagate MEDALIST 1080SL Product Manual page 110

100 Medalist 1080sl SCSI Product Manual, August 1995
ory data and the write counter are updated even after the
write life span is exceeded, but the integrity of the data
cannot be assured.
When the synchronous select mode (SSM) bit is 0, the drive
does not send a synchronous data transfer message unless
the initiator has already issued a synchronous data transfer
message. When the SSM bit is 1, the drive can send a
synchronous data transfer message, even when the initiator
has not sent a synchronous data transfer message.
When the disable unit attention (ATOFF) bit is 0, the drive
generates a unit attention condition during power up. When
the disable unit attention (ATOFF) bit is 1, the drive does
not generate a unit attention condition during power up.
When the Inquiry Queue Follow Mode (IQFM) bit is 0, the
CmdQue bit in byte 7, bit 1 of the Inquiry data reports that
the drive supports Tagged Command Queuing. When the
IQFM bit is 1, the CmdQue bit in byte 7, bit 1 of the Inquiry
data follows the state of the DQue bit Mode page 0A
3, bit 0.
The device type qualifier field is not supported.
Byte 3
Byte 4 The Spinup delay field controls the drive when it is not in
the remote start mode. When the value is 00
spins up without delay. When the value is FF
delays spinup to a duration whose value in seconds equals
five times the drive's SCSI ID address. When the value is
between 01
H
corresponding decimal duration in seconds.
and FE , the drive delays the spinup for the
H
, byte
H
, the drive
H
, the drive
H