Related Manuals for Grandstream Networks GXE502x
Summary of Contents for Grandstream Networks GXE502x
- Page 1 Grandstream GXE502x IPPBX Quick Start Guide...
- Page 2 Ready access to power and UPS or surge protector DHCP: dynamic host configuration protocol – automatically • DHCP must be configured with DHCP Option 66 enabled for Grandstream assigns IP addresses phones to be autoprovisioned (Grandstream default configuration. Non- Extension Length: number of characters in an extension. For Grandstream IP phones will need to be configured manually).
- Page 3 GXE Configuration Steps ONE. Access the web GUI (web configuration pages): 1. Connect a Windows PC to the same switch/hub that is connected to the GXE. 2. Click on the start menu and go to the “Run” option and type “cmd” to launch the Windows command prompt window.
- Page 4 DHCP Option 66 allowed to be auto-provisioned; these are factory default settings on Grandstream products as well as many others. Figure 2-2 To ensure proper auto-provisioning of Grandstream IP phones, connect the IP phones to the switch/hub after Step 3, as the GXE will only auto-provision phones found during this stage.
- Page 5 THREE: Manually Adding Extensions 1. If you need to add more extensions manually, you can click on “Add One Extension” or “Batch Add” to add multiple extensions at a time. Choosing “Add One Extension” will load the “Add Extension page” (See Figure 3-1); enter a User Name, Extension, and SIP Password.
- Page 6 FOUR: Configuring the Network Settings 1. Click on “System Configuration” in the left hand column. This will automatically load the Network Settings configuration page (See Figure 4-1). On this page you can configure the LAN and WAN settings such toggling between using DHCP or using a static IP address.
- Page 7 FIVE: Configuring the System Settings 1. Click on “System Configuration” in the menu bar on the left. 2. Click on “System Settings” in the expanded menu to load the system settings page (See Figure 5-1). This page lets you configure the login and contact information of the system administrator, email options, time zones, call record servers and storage quotas.
- Page 8 SIX: Configuring PSTN Lines (if available) 1. Click on TRUNK/Phone Lines on the left menu bar to load the Internal PSTN Trunk Line configuration page (See Figure 6-1). 2. All sections on this page except for the Line Call Control section are used to match the settings of the GXE to the local PSTN line parameters.
- Page 9 Figure 7-1 EIGHT: Configuring a Peer System (if available) 1. If you have more than one GXE502x, you can configure the units to be peers. To do this, click on “Advanced Options” in the menu bar to load the “Peer Systems” page.