Trouble Shooting - Husqvarna Auto Mower Operator's Manual

Observation
The Auto Mower goes
outside the cutting area
Uneven mowing result
The Auto Mower cuts at
the wrong time
The Auto Mower vibrates
Auto Mower runs around
but the cutting disc does
not rotate.
The mower runs for
shorter periods than usual
between recharging.
Mowing and charging
times are both shorter
than usual.

TROUBLE SHOOTING

Possible cause
If this only happens at certain places on
the lawn it may be caused by metal
objects (fencing, iron strengthening bars
etc.) or cables buried nearby.
The cutting area is sloping too steeply.
The boundary wire has been installed
incorrectly around an "island".
The boundary wire has been installed too
close to the edge of the area that you
want to use as the working area.
The Auto Mower is cutting too few hours
each day.
The working area is too large.
The blades are dull.
Grass is too long in relation to the set
cutting height.
Clumps of grass clippings on the cutting
disc or around the motor shaft.
The Auto Mower clock requires setting.
The cutting start and stop times are
incorrectly set.
Unbalanced cutting disc or damaged
blades.
Auto Mower is searching for the charging
station.
Grass or a foreign object is slowing down
the cutting disc or protective plate.
This is normal behaviour when the
temperature is high (gradually increasing
above 25°C/80°F).
Action
Check by moving the position of the
boundary wire.
Ensure that the boundary wire has been
installed in accordance with the installa-
tion instructions.
Ensure that the boundary wire has been
installed in accordance with the installa-
tion instructions.
Ensure that the boundary wire has been
installed in accordance with the installa-
tion instructions.
Lengthen the working time, see "Set-
tings".
Try reducing the size of the working area
or lengthening the working time, see
"Settings".
Change all three blades, to keep the
cutting disc balanced.
Raise the mowing height. Gradually lower
the cutting height until the desired height
has been achieved.
Use a small brush or wood dowel to clean
off the grass clippings. Check that the
cutting disc rotates freely.
Set the clock, see "Settings".
Set the mowing start and stop times
again, see "Settings".
Clean the cutting disc and/or change all
three blades. If cleaning is necessary
between the riveted discs, remove the
blades and clean using steel wire.
Replace the blades.
No action. The cutting disc does not
rotate when the mower is searching for
the charging station.
Clean the cutting disc and protective
plate.
19
English –