Use; Transport; Care - Husqvarna Auto Mower Operator's Manual

SAFETY GUIDELINES AND INFORMATION

Use

• Read through the Operator's Manual carefully and make sure
you understand its contents before using the Auto Mower.
• Read and follow instructions on mower and in owners
manual.
• Keep children out of mowing
area while Auto Mower is in
operation.
• Keep hands and feet away
from cutting deck and
mowing parts.
• Remove objects that could be
thrown by the blades.
• Check that there are no
stones, twigs, tools, toys or
other objects on the lawn that
can damage the blades or
cause the mower to stop.
• Start the Auto Mower in accordance with the instructions.
Keep your hands and feet away from the rotating blades.
Never put your hands or feet underneath the mower.
• Make sure that no one is standing in front of the Auto Mower
when you start it.
• Never lift up the Auto Mower or carry it around when it is
running.
• Do not let persons who do not know how the Auto Mower
works and behaves use the mower.
• Do not put anything on top of the Auto Mower or its charging
station.
• Do not allow the Auto Mower to be used if any part is seen to
be defective or faulty. This includes the cutting disc, blades,
nuts, bolts and cables.
• Do not use the Auto Mower if the power switch does not work.
• Always switch off the Auto Mower by means of the power
switch when it is not in use.
Starting the Auto Mower
The battery must be charged before starting when the Auto
Mower is new or has been stored for a long period, see "Charg-
ing an empty battery". In other cases the Auto Mower can be
started at any time within the mowing area, according to the
following:
• Lift the cover and switch on the switch. A long beep should be
heard.
• Enter your personal code,
0000 #, see the "Settings" section to select your personal
*
code.
• Lower the cover. The Auto Mower will either immediately start
to mow or seek out the charging station. If the Auto Mower
travels to the charging station with a fully charged battery it
will leave after a short while. If the battery needs to be
charged, it will remain there for sometime before leaving the
charging station.
2
– English
KEEP HANDS and FEET AWAY
code #. On delivery the code is
*
Stopping the Auto Mower
STOP
• Stop the Auto Mower by lifting up the rear cover. Enter the first
digit of the code to deactivate the theft alarm. Otherwise the
alarm will sound after approx. 6 seconds. The long beep heard
after lifting the rear cover confirms that cutting disc has stopped.
• Restart the Auto Mower by lowering the rear cover again.
• Always set the power switch to "STOP" if you intend to carry out
any maintenance on the Auto Mower or to move it outside of the
mowing area. When the switch is flipped to on, the personal
code, code #, must be entered.
*

Transport

STOP
!
WARNING!
Never move the Auto Mower with the cover
lowered. The blades can then rotate and cause
personal injury.
Moving the Auto Mower from or within the mowing area:
1. Lift the cover. The long beep after the cover has been lifted
indicates that the cutting disc has stopped.
2. Enter the first digit of your personal code to prevent the
theft alarm being activated.
3. Switch off the power switch if the Auto Mower is to be
moved outside of the mowing area. Otherwise this does not
need to be switched off.
4. Carry the Auto Mower by its handle.
Pack away the Auto Mower in the original packaging or in the
Husqvarna Auto Mower storage bag when transporting over
long distances.

Care

STOP
• Inspect the Auto Mower weekly and replace any damaged parts.
Check in particular that the cutting disc and blades are not
damaged. Change all the blades at the same time if replacement
is necessary so that the rotating parts are balanced, see the
"Maintenance" section.
• Clean the charging station's contact plates and the Auto Mower's
charging pins using a fine abrasive cloth if necessary. If black
oxide forms on the Auto Mower's charging pins this can be a sign
of inferior electrical contact between the charging pins and the
charging station's contact plates. Check the installation of the
charging station, refer to "Installation, step by step". Always check
whether cleaning is necessary with the first usage after the winter
break.
• Contact your local dealer when changing damaged or worn parts.
• Old batteries that have been replaced should be returned for
disposal to your dealer or to a recycling station.
!
WARNING!
The power switch must be switched off with all
work on the mower's chassis such as cleaning,
setting the cutting height or replacing the blades.
The power switch must always be switched off
when the machine is turned upside down.
If the mower's start-up signal has been switched
off you will not hear beeps warning for the start
of the cutting disc (5 beeps during 5 seconds).