Epson EB-Z8000WU User Manual page 62

Problem Solving
Check
Has condensation formed on the lens?
Interference or distortion appear in images
Check
Is the image signal format setting correct?
Only when projecting images from a video source
Are the cables connected correctly?
Is an extension cable being used?
Is the correct resolution selected?
Only when projecting computer images
g g
Are the "Sync. " and "Tracking " settings adjusted correctly?
Only when projecting computer images
The image is truncated (large) or small, or the aspect is not suitable
Check
Is the aspect adjusted correctly?
Is a wide panel computer image being projected?
Only when projecting computer images
Is the image still being enlarged by E-Zoom?
Is Position adjusted correctly?
If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient
temperature changes occur, condensation may form on the surface of the lens, and this may cause the images to
appear fuzzy. Set the projector up in the room about one hour before it is used. If condensation forms on the lens,
turn the projector off and wait for the condensation to disappear.
Change the setting according to the signal for the connected equipment. s Signal Menu - Video Signal
Check that all the cables required for projection are securely connected. s Quick Start Guide
If an extension cable is used, electrical interference may affect the signals. Use the cables supplied with the projector
to check if the cables you are using may be causing the problem.
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.93
Press the [Auto] button on the Remote Control or the [Enter] button on the Control panel to perform automatic
adjustment. If the images are not adjusted correctly after using automatic adjustment, you can make the adjustments
using Sync. and Tracking from the configuration menu. s Signal Menu - Tracking, Sync.
Press the [Aspect] button on the Remote Control to select an aspect suitable for the input source. s
Change the setting according to the signal for the connected equipment. s Signal Menu - Resolution
Press the [ESC] button on the Remote Control to cancel E-Zoom. s
Press the [Auto] button on the Remote Control or the [Enter] button on the Control panel to perform automatic
adjustment when the computer image is projected. If the images are not adjusted correctly after using automatic
adjustment, you can make the adjustments using Position from the configuration menu.
Apart from computer image signals, you can adjust other signals while projecting by adjusting Position from the
configuration menu. s Signal Menu - Position
Remedy
Remedy
s Computer documentation
Remedy
p.28
p.43
62
p.43
p.43
p.22
p.43