Changing The Projected Image; Automatically Detect Input Signal And Change The Projected Image (Source Search) - Epson EB-Z8000WU User Manual

Changing the Projected Image

You can change the projected image in the following two ways.
• Changing by Source Search
The projector automatically detects signals being input from connected
equipment, and the image being input from the equipment is projected.
• Changing directly to the target image
You can use the remote control buttons to change to the target input
port.
Automatically Detect Input Signal and Change
the Projected Image (Source Search)
You can project the target image quickly as input ports with no image
signal being input are ignored when you change by pressing the [Source
Search] button.
A
Computer
B
BNC
C
DVI-D
D
S-Video
E
Video
F
HDMI
Skipped when no image signal is being input.
Procedure
When your video equipment is connected, start playback before
beginning this operation.
Using the Remote Control
When two or more pieces of equipment are connected, press the
[Source Search] button until the target image is projected.
The following screen showing the status of image signals is
q
displayed when only the image that the projector is currently
displaying is available, or when no image signal can be found. You
can select the input port where the equipment you want to use is
connected. If no operation is performed after about 10 seconds, the
screen closes.
18
Using the Control panel