Epson EB-Z8000WU User Manual page 49

List of Functions
Sub Menu
Wired LAN
PJLink Password
Web Control Password
g
SNMP
You can make network settings.
DHCP: You can set whether or not (On/Off) to use DHCP.
If this is set to On you cannot set any more addresses.
IP Address: You can input the IP address assigned to the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following IP Addresses cannot be used.
0.0.0.0, 0.x.x.x, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Subnet Mask: You can input the subnet mask for the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following Subnet Masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: You can input the IP address for the gateway for the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following Gateway Addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
MAC Address: You can display the MAC address for the projector.
Set a Password to use when you access the projector using compatible PJLink software.
You can enter up to 32 single-byte alphanumeric characters.
Set a password to use when making settings and controlling the projector using Web Control.
alphanumeric characters.
Web control is a computer function that allows you to set up and control the projector by using a web browser on the computer
running EasyMP Monitor. s EasyMP Monitor Operation Guide
You can make SNMP settings.
Trap IP Address 1/Trap IP Address 2: You can register up to two addresses as the SNMP trap notification destination.
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be
managed by a network expert.
Function
*1
*1
*1
*1
p.92
s
*1
You can enter up to 8 single-byte
49
*1