Mounting The Devices On A Standard Mounting Rail - Siemens 340 Manual

Mounting

5.4 Mounting the devices on a standard mounting rail

5.4 Mounting the devices on a standard mounting rail
Requirements
● At the installation location, a horizontal 35 mm mounting rail in accordance with
DIN EN 60715 is properly secured
● Please observe the information about the mounting position in chapter "Mounting position
(Page 56)"
Procedure
Step
1 Hang the back of the device onto the upper
edge of the standard mounting rail
2 Press the lower half of the device against the
rail until the device engages
74
Operating instruction Figure
SIRIUS 3RM1 motor starter
Manual, 11/2013, A5E0345285095020A/RS-AB/002