Table of Contents
Advertisement
3.2
Connection box and wall bracket
3.2.1
Installing the Connection Box compact CA
Observe the safety and accident prevention instructions (Page 23) and the applicable
ESD guidelines.
You need 4 mounting clips from the product package for installation of the connection box
and a Phillips screwdriver, size 2.
Procedure
1.
2.
3.
4.
3.2.2
Mounting the wall-mounting bracket
Requirement
● In order to ensure that the HMI device can be hooked in securely, select a vertical
surface or one inclined slightly to the rear as the mounting surface.
● A position at eye level is recommended.
This enables convenient operation of the device in the wall bracket.
● Position the wall bracket so that the HMI device is not exposed to direct sunlight when
attached.
Mobile Client900WXN
Operating Instructions, 04/2015, A5E35883103-AB
Check for damage to the mounting seal on the
connection box. Do not install a connection box with a
damaged mounting seal.
Insert the connection box in the mounting cutout.
Secure the connection box to prevent it from falling
out.
Place one mounting clip into each of the four cutouts
marked.
Fasten the mounting clips. The permitted torque is
0.2 Nm.
Installing and connecting the device
3.2 Connection box and wall bracket
33
Advertisement
Table of Contents
