Xerox Phaser 3435 Service Manual page 145

5. Remove the three screws securing the Feed Bracket Unit and then remove the Feed Bracket
Unit and Feed 2 Shaft.
Feed2 shaft
6. If necessary, release the three E-Rings. Pull up the Feed 1 Roller from the Bushing, as the
Gears (T2 Idle, Retard, Idle) and then remove the Gears from the Feed Bracket, as shown
below.
Phaser 3435
Feed bracket unit
E-ring
Retard gear
Figure 4
Idle gear
Figure 5
5/08
Repairs and Adjustments
T2 idle gear
4-51