Storage; Maintenance; Operational Instructions; Swing Arm( - Stamina inLINE Back Stretch Bench Owner's Manual

STORAGE

1. To store the inLINE® Back Stretch Bench, simply keep it in a clean dry place.
2. Adjust the HEIGHT ADJUSTMENT BEAM(44) and MAIN FRAME(1) to the shortest position. The
inLINE® Back Stretch Bench is approximately 56 inches long x 18.5 inches wide x 14 inches tall.
These dimensions will vary. Please measure your inLINE® Back Stretch Bench if exact dimensions
are needed.
3. To move the inLINE® Back Stretch Bench, lift by the CUSHION(12) on one end and the HEIGHT
ADJUSTMENT BEAM(44) at the other end. Use caution as the SWING ARMS(6) may move and
cause a pinching hazard.

MAINTENANCE

The safety and integrity designed into the inLINE® Back Stretch Bench can only be maintained when
the inLINE® Back Stretch Bench is regularly examined for damage and wear. Special attention should
be given to the following:
1. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
2. Verify that the CAUTION LABEL(40) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(40) if it is missing or damaged.
3. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
4. Worn or damaged components shall be replaced immediately or the inLINE® Back Stretch Bench
removed from service until repair is made.
5. Only Stamina Products supplied components shall be used to maintain/repair the inLINE® Back
Stretch Bench.
6. Keep your inLINE® Back Stretch Bench clean by wiping it off with an absorbent cloth after use.

OPERATIONAL INSTRUCTIONS

STRETCH SYSTEM
The inLINE® Back Stretch Bench stretches the back with
its one way rack and pinion engineering. Lie on the inLINE®
Back Stretch Bench with the ARMPIT PADS(8) under your
armpits, and the FOAM PADS(24) holding your ankles. Pull the
LEVER(13) back and forth as many times as needed until you
feel a gentle stretch. Stop pulling at the desired position and stay
at the stretched position for a few minutes. Push the LEVER(13)
firmly toward your feet to release the stretch.
9
Push the Lever toward
your feet to release.
Pull the Lever back and forth
as many times as needed to
reach the proper stretch.