Pad Tube( - Stamina inLINE Back Stretch Bench Owner's Manual

ASSEMBLY INSTRUCTIONS
STEP 3
Pull the ADJUSTMENT KNOB(23) on the EXTENDING TUBE(2) and insert the HEIGHT ADJUSTMENT
BEAM(44) into the EXTENDING TUBE(2). Lock the HEIGHT ADJUSTMENT BEAM(44) in position
by inserting the pin of the ADJUSTMENT KNOB(23) into one of the adjustment holes in the HEIGHT
ADJUSTMENT BEAM(44) and tightening the ADJUSTMENT KNOB(23).
STEP 4
Insert the PAD TUBE(5) through the hole in the HEIGHT ADJUSTMENT BEAM(44) and secure with
BUTTON HEAD BOLT(M8x1.25x22mm)(34). Slide the FOAM PADS(24) on both ends of the PAD TUBE(5).
STEP 5
Refer to detail view A. Push in the BUTTON PIN(9) and insert the ADJUSTABLE INSTEP FRAME(45) into
the HEIGHT ADJUSTMENT BEAM(44).
NOTE: There are four adjustment holes in the HEIGHT ADJUSTMENT BEAM(44) which allow the
ADJUSTABLE INSTEP FRAME(45) to be attached in four different positions. Find the position
which is most comfortable for holding your ankles while performing the back stretching exercise.
Button Pin(9)
8
A.