Actuator Key And Actuator Lights (For Optional Equipment); Horn Key; Locking/Unlocking The Vsi; Off-Board Charger/Programming Socket - Pride Mobility Jazzy 1113 Owner's Manual

Actuator Key and Actuator Lights (For Optional Equipment)

Actuator keys and actuator lights are used for optional equipment such as power elevating seats or power elevating leg
rests. For specific operation of the actuator keys and actuator lights, contact your authorized Pride Provider.

Horn Key

The horn key activates the horn.

Locking/Unlocking the VSI

The VSI has a feature that enables you to lock your power chair to prevent unauthorized use.
To lock the VSI:
1. With the VSI switched on, press and hold the on/off key. After one second, the VSI should beep.
2. Release the on/off key.
3. Push the joystick to the full forward position until the VSI beeps.
4. Pull the joystick to the full rearward position until the VSI beeps.
5. Release the joystick. There should be a long beep.
6. The VSI is now locked.
To unlock the VSI:
1. Press the on/off key and power on the VSI. The maximum speed/profile indicator should ripple side to side.
2. Push the joystick to the full forward position until the VSI beeps.
3. Pull the joystick to the full rearward position until the VSI beeps.
4. Release the joystick. There should be a long beep.
5. The VSI is now unlocked.
NOTE: If the above procedure fails to either lock or unlock the VSI, contact your authorized Pride Provider.

Off-board Charger/Programming Socket

You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the front of the
VSI. See figure 32. If you use an off-board charger, the charger current should not exceed 8 amps. Contact your authorized
Pride Provider for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/
programming socket. See your authorized Pride Provider for more information.
NOTE: The socket may also be used for reprogramming the VSI. Contact your authorized Pride Provider for
more information.
NOTE: Changes to the programming can only be made by the manufacturer, an authorized representative of
the manufacturer, or an authorized Pride Provider.
Controller Connector
This connects the VSI to the power chair's batteries, motors, and motor brakes.
Jazzy 1113 ATS
V I I . O P E R A T I O N
www.pridemobility.com 37