On/Off Key; Battery Condition Meter; Speed/Profile Keys - Pride Mobility Jazzy 1113 Owner's Manual

On/Off Key

The on/off key turns the VSI on and off.
WARNING! Unless faced with an emergency situa-
tion, do not use the on/off key to stop the chair.
This will cause the power chair to stop abruptly.
WARNING! Always turn the power off when you are
stationary to prevent unexpected movement.

Battery Condition Meter

The battery condition meter is located in front of the joystick. See
figure 33. This is a 10-segment illuminated display that indicates that
the VSI is turned on and also gives the battery status, the VSI status,
and the electrical system status.
! Red, yellow, and green lights lit: Batteries charged; VSI and
electrical system OK.
! Red and yellow lights lit: Charge batteries if possible; VSI
and electrical system OK.
! Red lights only lit or slow flash: Charge batteries as soon as
possible; VSI and electrical system OK.
NOTE: When the batteries approach a discharged state, the
first red light will begin to slowly flash, reminding you the
batteries need to be charged immediately!
! Rapid flash of lights: Indicates a fault in the VSI or the electrical
system. Refer to "VSI Error Codes."
! Ripple side to side of lights: The joystick was not in the neutral position when the controller was turned on. If you
get "ripple side to side of lights," turn off the controller, allow the joystick to return to the neutral position, then turn on
the controller.
NOTE: If you still get "ripple side to side of lights," contact your authorized Pride Provider.

Speed/Profile Keys

There are two keys that control either the speed or the profile. See figure 33. This depends on how your VSI was
programmed. Press the speed/profile increase key to increase the speed or change the profile. Press the speed/
profile decrease key to decrease the speed or change the profile. The speed/profile setting is displayed on the
maximum speed/profile indicator. If your power chair was programmed with a drive profile, contact your authorized
Pride Provider for more information.
NOTE: We recommend that the first few times you operate your power chair, you set the speed to the
slowest setting until you become familiar with your new power chair.
36
V I I . O P E R A T I O N
www.pridemobility.com
Figure 33. VSI Controller Keypad
Jazzy 1113 ATS