Typical System Sensors; Door/Window Sensor; Wireless Keypad - Linear DVS 1200 Installation Instructions Manual

3. TYPICAL SYSTEM SENSORS

DOOR/WINDOW SENSOR

Sensor mounts on door or window with
adjacent magnet.
Opening door or window moves magnet away,
triggering sensor.
Pressing the case causes sensor to send a test
signal.
Jumper inside for INSTANT or DELAYED
alarm setting.
Press the case for testing, the red transmit
light shows that battery is in good condition.
Internal lithium batteries are monitored by the
Console.
Sends hourly status reports to the Console.
Up to 3 years battery life (depends on
frequency of activation). (UL tested for 1 year
minimum.)
Sensor contains internal terminals for
connection to glass break detector and
external switches.

WIRELESS KEYPAD

For controlling the system without having to
go to the Console.
Emergency and fire alarm can be triggered
from wireless keypad at any time.
UL NOTE: For personal emergency use only. Not
for use as a UL Listed Medical Alert System.
Green operation light.
Internal 9-volt battery is monitored by the
Console.
Keypad's beeper will buzz during
transmissions when the battery is low.
Up to 3 years battery life (depends on
frequency of activation). (UL tested for 1 year
minimum.)
Sends hourly status reports to the Console.
Press the [(A)] key to activate the automation
output.
Pressing [ ] clears the keypad.
Holding [ ] for two seconds sounds the mode
beeps from the Console.
Off Mode: 1 "Gong"
Chime Mode: 1 "Gong" & 1 "Beep".
Home Mode: 1 "Gong" & 2 "Beeps".
Away Mode: 1 "Gong" & 3 "Beeps".
Test Mode: 1 "Bing" & 4 "Beeps".
5