Communicator Programming; Setup Mode - Linear DVS 1200 Installation Instructions Manual

13. COMMUNICATOR PROGRAMMING

SETUP MODE

To perform any of the communicator
programming steps, the Console must be in
the Setup Mode.
Each programming function is performed with
similar keystrokes. After the Console is in
Setup Mode, enter the programming step
number, press the [ HOME ] key (HOME =
program), enter the new value, and press the
[ AWAY ] key (AWAY = store). Follow the
figures next to the programming step.
Start with the Console in Test Mode (Setup
Mode cannot be reached from any other
mode).
From Test Mode, enter the master user code
then press [ TEST ].
NOTE: Only the master user code can be used to
put the Console into the Setup Mode. The
restricted user codes cannot access Setup Mode.
A "gong" and five "beeps" will sound,
signaling that the Console is in Setup Mode.
Hold the [ OFF ] key for three seconds when
you want to exit Setup Mode.
NOTE: If the Console is left unattended in Setup
Mode, it will automatically switch back to Off Mode
after three minutes.
PROGRAMMING
STEP #
FUNCTION
76 2-WAY AUDIO
VOICE RESPONSE FROM CONSOLE SPEAKER
78
(AND REMOTE SPEAKER IF USED)
100 REMOTE PROGRAMMING LOCKOUT
101 CALL LIMITER
103 DIALING DELAY
104 DIALING METHOD
107 COMMUNICATOR ENABLE
32
GENERAL COMMUNICATOR OPTIONS
0 = NONE; 1 = LISTEN; 2 = 2-WAY MANUAL; 3 = 2-WAY FULL DUPLEX
0 = VOICE RESPONSE DISABLED
1 = VOICE RESPONSE ENABLED
0 = UNLOCK; 1 = LOCK
0 = OFF; 1 = FIVE CALLS PER ARMING PERIOD
0 = NO DELAY; 1 = 30 SECOND DELAY
0 = TONE; 1 = PULSE
0 = COMMUNICATOR OFF, 1 = COMMUNICATOR ON
General Communicator Programming Table
SETUP MODE
START IN TEST
MASTER
USER
CODE
1 GONG &
TEST
5 BEEPS
POSSIBLE
VALUES
FACTORY INSTALLATION
VALUE VALUE
0
0
0
0
0
0
0