General Communicator Options; Communicator Enable; 2-Way Audio; Voice Response - Linear DVS 1200 Installation Instructions Manual

Supervised wireless security console

Hide thumbs Also See for DVS 1200:

Software manual (48 pages)

Installation & programming instructions (44 pages)

Installation instructions manual (44 pages)

Table Of Contents

Table of Contents

COMMUNICATOR ENABLE

The factory setting for the Console disables

the communicator. If the system is going to be

a non-monitored, local alarm only, leave the

communicator disabled.

If the system is going to be monitored by a

Central Station, enable the communicator with

this programming step.

2-WAY AUDIO

When the Model VB-2 audio module is

installed, the communicator can provide

2-way audio capability.

The audio module can be programmed for

listen only, 2-way manual operation (using a

pushbutton telephone at the Central Station),

and 2-way full duplex hands free operation.

Refer to the VB-2 installation instructions for

details on operating the audio module.

NOTE: The Model VB-2 Digital Voice Synthesis

module must be installed for this option to

function.

The factory setting for the VB-2 audio module

is OFF.

Alternately, the audio module can be set for

(1) listen-only, (2) 2-way manual, (3) 2-way

full duplex.

VOICE RESPONSE

The Console can be programmed to allow its

speaker to play audio produced by the VB-2

or VB-3 digital voice synthesis modules.

This selection can also be used when a remote

speaker is connected to the Console.

The factory setting is to disable the Console's

speaker from playing voice module audio.

Alternately, the Console can be programmed

to enable voice module audio.

NOTE: Turning voice response OFF with this

programming step will only effect the audio

produced by the voice module. It will not stop the

Console's speaker from sounding local sirens and

tones.

NOTE: A Model VB-2 or VB-3 Digital Voice

Synthesis module must be installed for this option

to function.

REMOTE LOCKOUT

The factory setting for the communicator is to

allow remote connection to the Console with

Linear's RA-2400 Remote Access Software

and a modem (unlocked).

Alternately, the Console can be programmed

to not answer incoming calls, thereby, not

allowing remote access (locked).