Graco 206405 Instructions And Parts List page 14

M
2
30 31 37
54
3
L
1
58 53
†
1 To remove toggles: push in, swing up, ease out.
Push toggles (M) in and then up (shown in down position).
2
3 Turn wires up.
Fig. 7
10. Remove the lockwires (34
nuts (33 ) of the transfer valves. Screw the top
†
nuts off. Screw the poppet valve stems (45
the grommets (32 ) and the bottom nuts (30). Take
†
the valve poppets off the stems and squeeze them
firmly to check for cracks. See Fig. 7.
WARNING
To reduce the risk of pinching or amputating your
fingers, always keep fingers clear of the toggle
assemblies (M).
11. Grip the pivot pins (30) with pliers. Compress the
springs (31), and swing the toggle assembly (M)
up and away from the piston lugs (L). Remove the
parts. Check to see that the valve actuator (35) is
supported by the spring clips (58) but slides easily
into them. See Fig. 7.
12. Remove the trip rod yoke (28), actuator (35) and
trip rod (54). See Fig. 7. Check the exhaust valve
poppets (53 ) for cracks. To remove the exhaust
†
valve poppets (53 ), stretch them out and cut them
†
with a sharp knife.
13. Remove one muffler plate (20 or 40). Pull the
piston (59) up out of the base. Remove the throat
packing nut (42) and packings. See Fig. 6.
14 306531
Air Motor Service
28
34
†
33
45
32
59
55
33 45
† †
04118
) from the adjusting
†
) out of
†
54
58
35
†
†
†
1
Cut off tops of poppets as indicated by dotted lines.
Fig. 8
Reassembly
1. Clean all the parts in a compatible solvent and
inspect for wear or damage. Check the polished
surfaces of the piston (59), piston rod (41), and
cylinder wall (51) for scratches or wear. A scored
rod will cause premature packing wear and leak-
ing. Use all the repair kit parts and replace other
parts as necessary.
2. Lubricate all parts with a light, waterproof grease.
3. One at a time, install these parts in the base (55):
the gland (49*), five v-packings (48*) with lips
facing down, bearing (50*), backup washer (43),
flat packing (44*), and loosely screw in the packing
nut (42). Be sure the o-rings (38 & 39
place. See Fig. 6.
4. Pull the exhaust valve poppets (53
actuator (35) and clip off the top part shown with
dotted lines. See Fig. 8.
5. Install the grommets (32
(35). Install the trip rod (54) in the piston (59).
Place the trip rod yoke (28) and valve actuator (35)
on the trip rod. Be sure the o-ring (36*) is in place
and that the valve actuator is supported by the
spring clips (58), and reassemble the valve
mechanism. See Fig. 7.
1
53
Cutaway View
) are in
†
) into the valve
†
) in the valve actuator
†
†
45
†
33
†
32
†
33
†
36
†
0.145"
(3.7 mm)
45
†
59
04119