......01494 Model 225852 Fire–Ball 300 shown GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441 Copyright 1955, Graco Inc. is registered to I.S. EN ISO 9001...
D The maximum fluid working pressure of these pumps, when operated at a maximum of 180 psi (12.6 bar) air pressure is 900 psi (60 bar) on the 5:1 Fire-Ball 300 Pump, and it is 1800 psi (120 bar) on the 10:1 Fire–Ball 425 Pump.
Page 3
WARNING WARNING SKIN INJECTION HAZARD Fluid from the dispensing valve, leaks, or ruptured components can inject fluid into your body and cause extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also cause serious injury. D Fluid injected into the skin may look like just a cut, but it is a serious injury.
WARNING WARNING FIRE AND EXPLOSION HAZARD Improper grounding, poor ventilation, open flames, or sparks can cause a hazardous condition and result in a fire or explosion and serious injury. D Ground the equipment. Refer to Grounding below. D If there is any static sparking or you feel an electric shock while using this equipment, stop dispensing immediately.
Page 5
The typical installation shown in Fig. 2 is only an installation guide; it is not an actual system design. Contact your Graco distributor for assistance in designing a system to suit your needs. A Maximum vertical lift, tank foot valve E Pipe: 1.5 or 2 in.
Page 6
For iron pipe, a shutoff valve may be used instead. The shutoff valve must close off 1/2 in. npt(f) openings for the Fire-Ball 300 pump, and it must close off 3/4 in. npt(f) openings for the Fire–Ball 425 pump.
Page 7
To order a thermal relief kit for the Fire-Ball 300 D Install the pump end of the air supply lines about pump—900 psi (62 bar) maximum working 24 in. (610 mm) above the floor.
Operation Pressure Relief Procedure 3. Disconnect the solvent supply, and connect the supply lines to the tank. WARNING 4. Connect the fluid supply hose from the pump to the dispensing valve. INJECTION HAZARD To reduce the risk of serious bodily Operating injury, including fluid injection, injury from moving parts, or splashing in the eyes or...
12 or 17 11 or 16 10 or 15 01498 Parts Lists Model 225852 Model 222062 5:1 Fire-Ball 300 Pump, Includes items 6, 7, 10 to 13 Hose Kit for Fire-Ball 300 pump No. Part No. Description Qty. No. Part No. Description Qty.
Graco warrants all equipment manufactured by it and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. As purchaser’s sole remedy for breach of this warranty, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment proven defective.