Table of Contents
Advertisement
TM
2.4. SkyTracker
NOTE: The SkyTracker
recommended that you read the entire manual and become familiar with the nomenclature and
functions of all components before starting the assembly.
STEP 1. Install batteries
The battery compartment is located at the back of the SkyTracker
compartment cover and gently pull out the battery holder from the compartment. Insert 4 fresh AA
batteries (not included) into the holder (Figure 5a). Since it is a tight fit, you may find that you cannot
put the battery cover back due to the wires. Straighten the battery holder wires, slide the battery
holder back into the battery compartment and leave the wires outside, as shown in Figure 5b. Then
push the battery holder wires down into the battery compartment, as shown in Figure 5c. Place the
battery cover back onto the battery compartment and push the cover hook up to secure the battery
cover (Figure 5d)
Camera Mount Assembly
TM
mount is a precision astronomical instrument. It is highly
Battery wires
(a)
Push wires down
into battery
compartment
(c)
Figure 5. Install batteries
TM
mount (Figure 4). Lift the battery
6
Leave wires
outside battery
compartment
(b)
Lock battery cover
(d)
Advertisement
Table of Contents
