iOptron SkyGuider Pro Installation

Tool needed: a set of metric hex key wrench
1. Loosen two screws at the front of the mount and
two others on the top of a SkyGuider Pro main
board cover and remove the black cover.
2. Unplug the 6-wire motor driver cable and DC power
cable. Remember how wires wrapped.
Wire wrapping
3. Remove two mounting screws.
4. Gently pull the circuit board with sockets end up
and slide the circuit board out. If the board is stuck
by the motor, loosen two Phillips screws hold the
motor.
Motor screws
5. Unscrew and remove the polar scope LED board
and disconnect wire harness from the main board.
iPolar Installation –SkyGuider Pro (#3339R-SGP)
6. Remove polar scope cover and base.
7. Rotate the RA axis to find TWO set screws next to
the LED board, which are used to secure the polar
scope in place. Use a 1.5mm hex key to release the
set screws.
8. Pull the polar scope out of the RA axis.
9. Insert the iPolar into the RA axis. Rotate it to align
the USB port to the DEC bracket. Lock the set screw
gently to secure the iPolar.