Ethernet Networking - Lexmark S510 Series Quick Reference Manual

Networking
> Setup > > Network Setup >
Setup > > Wireless > > Wi‑Fi Protected Setup >
2
Follow the instructions on the printer display.
U P I N
SE THE ERSONAL DENTIFICATION UMBER
1
From the printer control panel, navigate to:
> Setup > > Network Setup >
Setup > > Wireless > > Wi‑Fi Protected Setup >
2
Follow the instructions on the printer display.

Ethernet networking

Information you will need to set up the printer on an Ethernet network
To configure your printer for an Ethernet network, organize the following information before you begin:
Note: If your network automatically assigns IP addresses to computers and printers, continue on to
installing the printer.
• A valid, unique IP address for the printer to use on the network
•
The network gateway
•
The network mask
• A nickname for the printer (optional)
Note: A printer nickname can make it easier for you to identify your printer on the network. You
can choose to use the default printer nickname, or assign a name that is easier for you to
remember.
You will need an Ethernet cable to connect the printer to the network and an available port where the
printer can physically connect to the network. Use a new network cable when possible to avoid potential
problems caused by a damaged cable.
Installing the printer on an Ethernet network
Before you install the printer on an Ethernet network, make sure that:
• You have completed the initial setup of the printer.
• Your network is set up and working properly.
•
Your computer is connected to your network.
For Windows users
1
Obtain a copy of the software installer package.
• From the Software and Documentation CD that came with your printer
> Wireless 802.11b/g/n > > Network Connection
> WPS PBC Mode >
(PIN)
METHOD
> Wireless 802.11b/g/n > > Network Connection
> WPS PIN Mode >
• From our Web site:
Go to http://support.lexmark.com, and then navigate to:
SUPPORT & DOWNLOAD > select your printer > select your operating system
2 Close all open software programs.
3 Double-click the software installer package.
Wait for the installation dialog to appear.
If you are using a Software and Documentation CD and the installation dialog does not appear, then
do the following:
In Windows 8
From the Search charm, type run, and then navigate to:
Apps list > Run > type D:\setup.exe > OK
In Windows 7 or earlier
a Click , or click Start and then click Run.
b
In the Start Search or Run dialog, type D:\setup.exe.
c
Press Enter, or click OK.
Note: D is the letter of your CD or DVD drive.
4 Click Install, and then follow the instructions on the computer screen.
Note: Select Ethernet connection when prompted to select a connection type.
For Macintosh users
1
Close all open applications.
2
Insert the Software and Documentation CD.
If the installation dialog does not appear after a minute, then click the CD icon on the desktop.
3
Double-click the software installer package.
4
Follow the instructions on the computer screen.
Note: Select Ethernet connection when prompted to select a connection type.
45