Maintenance And Troubleshooting - NordicTrack 29835.1 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 22.
HOW TO CALIBRATE THE RAMP
If the ramp is not functioning properly, the ramp may
need to be calibrated. To calibrate the ramp, press and
hold the 15 Calorie Workouts button for several sec-
onds until the test mode appears in the display.
Press the 15 Calorie Workouts button again. Then,
press the 1 Step Power Ramp increase or decrease
button to calibrate the ramp. The ramp will move
upward and downward as it calibrates.
When the ramp stops moving, the ramp is calibrated.
Then, press the 15 Calorie Workouts button repeatedly
to exit the test mode.
HOW TO GREASE THE PEDAL ARM ROLLERS
See the EXPLODED DRAWING near the end of this
manual. If the Pedal Arm Rollers (51) squeak when
moving on the Left and Right Tracks (16, 146), apply a
small amount of white marine grease equally to each
Pedal Arm Roller. Spread the grease evenly around
the Pedal Arm Rollers. Pedal the elliptical until a thin
film of grease is distributed along the Left and Right
Tracks; then, wipe off any excess grease.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must first remove the
shield cover and center shield assembly and the pulley
cover (see the instructions below).
First, remove the two indicated M4 x 16mm Screws
(101) from the Center Shield (76). Next, using a flat
screwdriver, release the tabs on the sides and rear of
the Shield Cover (75). Then, slide the Center Shield
and Shield Cover forward.
75
101
Next, see EXPLODED DRAWING A on page 33.
Remove the four M4 x 16mm Screws (101) from the
Pulley Cover (15), and then remove the Pulley Cover. It
may be necessary to disconnect the wires (not shown)
at the top of the Pulley Cover.
27
76