NordicTrack 29835.1 User Manual page 13

11. Apply grease to a Short Axle (149) and to two
M8 x 22mm Washers (97).
Next, tighten an M8 x 16mm Screw (82) and an
M8 x 22mm Washer (97) a few turns into the
Short Axle (149).
While a second person holds the front end of
the Right Link Arm (59) inside the bracket on the
Right Upper Body Leg (60), insert the Short Axle
(149) through both parts.
Tighten another M8 x 16mm Screw (82) and an
M8 x 22mm Washer (97) a few turns into the
Short Axle (149). Then, tighten both Screws at
the same time. time.
Repeat this step on the other side of the
elliptical.
12. Identify the Right Inner and Outer Leg Covers
(83, 69) and orient them as shown.
Press the Right Inner and Outer Leg Covers
(83, 69) together around the Right Upper Body
Leg (60).
Attach the Right Inner and Outer Leg Covers
(83, 69) to the Right Upper Body Leg (60) with
an M4 x 16mm Screw (101). To avoid damag-
ing the plastic, do not overtighten the Screw.
Attach the Left Inner and Outer Leg Covers
(72, 70) in the same way.
11
12
70
72
13
60
Grease
82
97
149
97
82
59
101
83
60
69