Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and
properly tighten all parts each time the elliptical is
used. Replace any worn parts immediately. Use only
manufacturer-supplied parts.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power cord is fully plugged in and that the power
switch is in the reset position. If there are exterior wires
on the console, make sure that the connectors on the
wires are oriented correctly and are connected firmly.
If you are having problems connecting the console
to a wireless network or if you are having problems
with your iFIT account or iFIT workouts, go to
support.iFIT.com.
If the console does not boot
up properly, or if the con-
sole freezes and does not
respond, reset the console
to the factory default set-
tings. IMPORTANT: Doing
this will erase all custom settings you have made
to the console. Resetting the console requires two
people. First, press the power switch and unplug the
power cord. Next, locate the small reset opening (A) on
the back or the side of the console. Using a bent paper
clip, press and hold the reset button inside the open-
ing, and have a second person plug in the power cord
and press the power switch. Continue holding the reset
button until the console turns on. When the reset oper-
ation is complete, the console will turn off and then turn
back on. If it does not, press the power switch off and
then on again. Once the console turns on, check for
fi rmware updates (see HOW TO CHANGE CONSOLE
SETTINGS on page 27 on page 28). Note: It may
take a few minutes for the console to be ready for use.
INCLINE SYSTEM TROUBLESHOOTING
If the ramp does not move to the correct incline level,
see step HOW TO CHANGE CONSOLE SETTINGS
on page 27 and calibrate the incline system.
32
A
Advertisement
Table of Contents
