Miele KM 326G Operating Instructions Manual page 24

Wok burner outer ring conversion
A
The wok burner outer ring injector is located on
the right hand side of the wok burner body (B).
1. Unscrew the screw holding the brass tube to
the left of the injector. Access this screw
from the rear. Slide the brass tube to the left,
but do not insert it into the aluminium tube all
the way.
2. Use a 10 mm wrench and unscrew the outer
ring injector. Support the aluminium gas pipe
feeding the injector by holding it down, while
turning the wrench. Unscrew the injector
and replace it with the injector marked 090
(170, natural gas).
22
B
Outer ring injector (B)
Note
A
Adjust the air slot on the outer ring injector now.
The correct distance for the air slot (B) is 0.083".
Slide the brass tube to the prescribed distance
and tighten the holding screw at the rear of the
tube.
Wok burner inner ring conversion
A
The inner ring injector is located on the left
hand side of the wok burner body (A).
B
Outer ring airslot (B)
B
Inner ring injector (A)