Table of Contents
Advertisement
Electrical connection
The automatic ignition and the safety device
require connect ion to an A.C. single phase
120 V, 60 Hz supply. Fuse rating 6 A.
The appliances are factory equipped with a
power supply cord with molded three prong plug
– ready for connection to an electrically
grounded socket which complies with your local
electrical codes or with the National Electrical
Code ANSI/NFPA No. 70 for the USA or
Electrical Code Part I for Canada.
Ensure that the receptacle is positioned so that
it is easily accessible when the appliance is
built in.
Check that the data given on the data plate
under the appliance complies with the mains
voltage.
Warning:
This appliance must be grounded.
Do not cut or remove the grounding prong from
the plug.
12
Gas connection
These appliances must be installed with a
separate shut-off valve and a gas pressure
regulator.
Both shut-off valve and pressure regulator must
be easily accessible to the consumer.
The shut-off valve is solely intended to be used
to shut off the gas supply.
This appliance and its individual shut-off valve
must be disconnected from the gas supply
piping system during any pressure testing of that
system.
The hob comes equipped for natural gas.
You should find out details about the type of gas
and calorific value from your Gas Utility and
compare this information with the type of gas
quoted on the data plate.
Before using the appliance, check the
connection with a soapy solution for leaks.
Never use a flame of any sort. The interior of
this appliance has been tested by the
manufacturer.
Pressure regulator
A pressure regulator is included with the
appliance.
After installing a gas shut-off valve in an easily
accessible location under the hob, install the
gas pressure regulator to the manifold pipe
using pipe dope on threads of the manifold pipe
(see also next page).
Hide quick links:
Advertisement
Table of Contents
