Conversion Instructions - Miele KM 326G Operating Instructions Manual

Conversion instructions

Caution
Before proceeding with the conversion, shut off
the gas supply to the appliance prior to
disconnecting the electrical power.
Disassembly
Shut off gas supply, disconnect the manifold
pipe, disconnect the electrical power. Remove
pan supports, burner heads and burner rings.
Remove control knobs.
In the event that the hob is built in, undo the
bracket clamps underneath the work surface.
Lift the hob on to the work surface.
Unscrew the venturis on the high-speed and
super high-speed burners using a 20 mm
wrench. Lift and remove the burner rings and
burner base plates. Disconnect the wires from
the ignition plugs. Keep the wire from dropping
into the undertray by inserting it in one of the
slots in the burner supports.
Remove the top five screws in the back of the
hob undertray.
20
Remove the three screws securing the dual ring
wok burner. Remove the wok burner base plate.
Lift the ceramic tray from the hob.
Note
Each regulator shaft is equipped with a black
ring. This ring may cling to the rubber seal in the
ceramic tray. Check and remove the rings from
the rubber seals.
For future use
Save the orifices removed from the appliance
for future use. For converting this appliance
back to Natural gas, follow the instructions and
use the numbers in brackets (... ).
Igniter
The relationship between the igniter and the
main burners can't be changed. The relationship
in the case of LP gas and natural gas is identical.
The distance between the igniter and the high
speed burner and super high speed burner is
± 3.5 mm. For the two zone
high speed burner the
distance between the
igniter and the inner ring is
± 2.5 mm.