Troubleshooting - Miele KM 326G Operating Instructions Manual

Troubleshooting

Problem
Burner does not burn well
Ignition sparks but burner
does not ignite
Ignition does not spark
If your appliance does not operate as desired,
first check if you can solve the problem yourself
by using the table above. There is often a simple
reason for the problem.
Repairs to the gas and electrical components of
this appliance must only be carried out by a
suitably qualified person (licensed gas fitter in
Canada).
Repairs by unauthorised personnel could be
dangerous and are not covered by the
guarantee.
10
Cause
– Burner dirty or moist
– Not suitable for type of gas
– Burner dirty or moist
– Burner cap not aligned
properly
– The appliance has not yet
been plugged in properly
– Ignition is defective
In the event of any fault on this appliance,
please contact:
– your Miele dealer or
– the Miele Service Department,
the address of which is shown on the back
page.
Please quote the model and serial number of
your appliance. You will find both on the data
plate located on the underside of the appliance.
Solution
– Clean and/or dry the burner
– Check identification plate
and if necessary have the
appliance adapted
– Clean and/or dry the burner
– Position the cap properly
onto the ring
– Plug in the appliance
properly
– Phone the Miele Service
Department