1. Manuals
  2. Brands
  3. Miele Manuals
  4. Hob
  5. KM 3014
  6. Operating and installation instructions

Miele KM 3014 Operating And Installation Instructions

Gas hobs town gas or lp gas
Hide thumbs Also See for KM 3014:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Operating and Installation Instruction
Operating and installation instructions
Gas hobs
KM 3014 (Town Gas or LP Gas)
en - HK
To avoid the risk of accidents or
damage to the appliance it is
essential to read these
instructions before it is installed
and used for the first time.
M.-Nr. 09 316 120

Advertisement

Table of Contents
loading

Related Manuals for Miele KM 3014

Summary of Contents for Miele KM 3014

  • Page 1 Operating and installation instructions Gas hobs KM 3014 (Town Gas or LP Gas) en - HK To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time.
  • Page 2 Per questo se si vuole usare l’apparecchio in un paese diverso rivolgersi al servizio di assistenza tecnica Miele del paese in cui si intende usarlo.
  • Page 3 Gas-heated appliances Safety precautions to take if you smell gas ß Turn off the gas emergency control valve immediately. This is usually located near the gas meter. ß Eliminate all sources of ignition in a safe manner. Do not smoke, light cigarette lighters or matches. ß...

  • Page 4: Table Of Contents

    Contents Description of the appliance ......... 5 Accessories supplied .

  • Page 5: Description Of The Appliance

    Description of the appliance KM 3014 a Wok burner Cooking zone controls: b Small burner f Front right c Medium burner g Rear right d Pan support (for each burner) h Left e Cooking zone symbol...
  • Page 6 Description of the appliance Burner Wok burner a Outer burner cap b Inner burner cap c Burner head d Burner base e Ignition safety device f Ignitor Small and medium burners a Burner cap b Burner head c Burner base d Ignition safety device e Ignitor...

  • Page 7: Accessories Supplied

    Description of the appliance Accessories supplied The accessories supplied with your appliance as well as a range of optional ones are available to order from Miele (see "Optional accessories"). Combi insert If you are using a pan which is smaller than recommended in the chart under "Pans", then the combi insert supplied should...

  • Page 8: Warning And Safety Instructions

    Any other use is not supported by the manufacturer and could be dangerous. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. The gas hob is not intended for outdoor use.
  • Page 9 Warning and Safety instructions Safety with children This appliance is not a toy! To prevent the risk of injury, do not allow children to play with the appliance or its controls. Children under 8 years of age must be kept away from the hob unless they are constantly supervised.
  • Page 10 It is most important that this basic safety requirement is observed and tested regularly, and where there is any doubt, the household wiring system should be inspected by a qualified electrician. Miele cannot be held liable for the consequences of an inadequate earthing system (e.g. electric shock).
  • Page 11 The hob is not intended for use with an external timer switch or a remote control system. If the connection cable is damaged, it must be replaced by a suitably qualified electrician with a special connection cable of type H 05 V V-F (pvc insulated), available from the Miele Spare Parts Department.
  • Page 12 Warning and Safety instructions Do not connect the appliance to the mains electricity supply by a multi-socket adapter or an extension lead. These do not guarantee the required safety of the appliance (e.g. danger of overheating). Do not use the hob if if it is faulty, or if the ceramic surface is cracked, chipped or damaged in any way.
  • Page 13 If the pan diameter is too large, flames can spread out to the sides and damage or burn the worktop, wall claddings or surrounding units and also parts of the hob. Miele cannot be held liable for this type of damage.
  • Page 14 Warning and Safety instructions Ensure that the flames from the burner do not spread out beyond the base and up the sides of the pan. Unless the pan manufacturer states that you can do so, do not use pans with very thin bases on this hob, and never heat up empty pans as they could get damaged.
  • Page 15 If the appliance has not been used for a longer period of time it should be thoroughly cleaned before it is used again. It is also advisable to have the appliance tested for safety. Miele cannot be held liable for damage caused by non-compliance with these Warning and Safety instructions.

  • Page 16: Caring For The Environment

    Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment.

  • Page 17: Before Using For The First Time

    Before using for the first time Please stick the extra data plate for the appliance supplied with this documentation in the space provided in the "After sales service, data plate" section of this booklet. Cleaning for the first time ^ Remove any protective foil. ^ Clean all removable parts of the burners with a solution of warm water and a little washing-up liquid applied with a soft sponge.

  • Page 18: Operation

    Operation Controls The control is used to ignite the burner and to regulate the strength of the flame. Small and medium burners ß The gas supply is turned off & Strongest flame / Weakest flame Wok burner ß The gas supply is turned off &/ Strongest flame: The inner and outer burners operate at the highest setting.

  • Page 19: Switching On

    Operation Switching on ^ The control for the burner required must be pressed in and turned anti-clockwise to the largest flame symbol to switch When a control is operated, a spark is produced on all cooking zones. This is not a fault. ^ When the flame ignites, keep the control pressed in for 5-10 seconds, and then let it go.

  • Page 20: Regulating The Flame

    Operation Regulating the flame Regulate the flame so that it does not spread out beyond the sides of the pan. As the outer part of the flame is much hotter than the centre, the tips of the flames should stay beneath the pan base.

  • Page 21: Suitable Pans

    Suitable pans Burner Min. pan base diameter in cm Small burner Medium burner Wok burner Max. diameter at top of pan in cm Small burner Medium burner Wok burner – Refer to the chart above and ensure that the pan diameter falls within the minimum and maximum diameters given for the burner you are using.

  • Page 22: Combi Insert

    Suitable pans Combi insert The combi insert must be utilised when using pans with a base diameter of less than the minimum given in the table above. The combi insert ensures that the pan will sit securely on the hob, and cannot tip up. Wok ring The Wok ring supplied with your appliance can be used in instances where extra stability is required.

  • Page 23: Energy Saving Tips

    Energy saving tips – Use a pan lid whenever possible to minimise heat loss. – Cook with as little water as possible. – Cooking times are greatly reduced when using a pressure cooker. – Turn the flame down promptly to a lower setting when the pan has come to the boil.

  • Page 24: Safety Features

    Safety features Thermo-electric ignition safety device This appliance is has a thermo-electric ignition safety device. If the flame goes out, for example if food has boiled over or if there is a sudden draught, and automatic re-ignition has been unsuccessful, the supply of gas to the burner will be cut off, preventing any further escape of gas.

  • Page 25: Cleaning And Care

    Cleaning and care Do not use a steam cleaning appliance to clean this appliance. The steam could reach electrical components and cause a short circuit. – The appliance should be cleaned after each use. Allow the appliance to cool down to a safe temperature before cleaning.
  • Page 26 It will form an invisible coating which will cause permanent Clean with Miele ceramic glass and stainless steel discolouration of the cleaner (see "Optional Accessories"), or with ceramic surface which another proprietary ceramic glass cleaner and cannot be removed.
  • Page 27 Cleaning and care To assemble the small and medium burners ^ Place the burner head b on to the burner base c so that the ignition safety device d and the ignitor e extend through their respective holes in the burner head. The burner head must click into place correctly.
  • Page 28 Cleaning and care To assemble the wok burner ^ Place burner head c onto burner base d so that the ignition safety device e and the ignitor f extend through their respective holes in the burner head. The burner head must click into place correctly.

  • Page 29: Problem Solving Guide

    The burner head or burner cap Remove any soiling. holes are dirty. The ignitor on the Check whether the mains fuse Call a suitably qualified electrician or Miele burner does not has tripped. Service. spark. Food residues between the If there is, remove it carefully (see "Cleaning...

  • Page 30: Optional Accessories

    Optional accessories Miele offer a comprehensive range of useful accessories as well as cleaning and conditioning products for your appliance. These products can be ordered online: or from Miele (see back cover for contact details) Ceramic and stainless steel hob cleaner...

  • Page 31: Safety Instructions For Installation

    Safety instructions for installation Do not use any sealant except Fit the wall units and extractor hood where expressly instructed to do so. before fitting the hob to avoid The seal underneath the appliance damaging the surface. provides a sufficient seal for the worktop.
  • Page 32 Safety instructions for installation Safety distance above the appliance A minimum safety distance must be maintained between the appliance and the cooker hood above it. See the cooker hood manufacturer's operating and installation instructions for details. If the manufacturer's instructions are not available for the cooker hood, a minimum safety distance of at least 760 mm must be maintained.
  • Page 33 Safety instructions for installation Safety distances to the sides of the Ideally the hob should be installed with plenty of space on either side. There may be a wall at the rear or a tall unit or wall on one side (right or left) (see illustrations).

  • Page 34: Appliance And Building-In Dimensions

    Appliance and building-in dimensions KM 3014 a Front b Casing depth c Casing depth including mains connection box d Gas connection R 1/2 - ISO 7-1 (DIN 10226)

  • Page 35: Installation

    Installation ^ Make the worktop cut-out according to the dimensions given in the building-in dimension diagram. Remember to maintain the minimum safety distances (see "Safety instructions for installation"). ^ Seal the cut surfaces on wood/laminated worktops with a suitable heat-resistant sealant to avoid swelling caused by moisture.

  • Page 36: Tiled Worktop

    Installation Seal between appliance and Tiled worktop worktop Grout lines a and the hatched area underneath the hob frame must be The sealing strip under the edge of the smooth and even. If they are not the top part of the appliance provides a hob will not sit flush with the worktop sufficient seal for the worktop.

  • Page 37: Electrical Connection

    Electrical connection Connection should be made via a All electrical work should be carried suitable isolator or a double pole fused out by a suitably qualified and spur connection unit which complies competent person, in strict with national and local safety accordance with current local and regulations and the on/off switch should national safety regulations.
  • Page 38 If the connection cable is damaged, it must be replaced by a suitably qualified electrician with a special connection cable of type H 05 V V-F (pvc insulated), available from the Miele Service Department. The manufacturer cannot be held liable for damage which is the direct or indirect result of incorrect installation or connection.

  • Page 39: Gas Connection

    Gas connection According to the Gas Safety The gas installation must be carried Regulations of Hong Kong, any gas out so that the connection is not installation works including the subject to high temperatures when installation of appliances and the appliance is in use. connection tubing, must be It is particularly important that the undertaken by registered gas...
  • Page 40 Gas connection Town Gas Connection: The external gas governor (MDG ELITRE with model no. EL-125, Please use approved gas tubing pressure setting at 10 mbar) comes bearing EMSD approval marking (such with the Town Gas connection hob. as: EMSD APPROVAL GTXXXX) for connection to appliances, or other appropriate methods accepted by EMSD.
  • Page 41 Gas connection Connecting the appliance Using a 90° angle The gas connection of the appliance has a 1/2" tapered screw thread. Connection can be made by: – an appropriate rigid connection – a flexible gas connection pipe in accordance with DIN 3383 Section 1 A flexible gas connection pipe must not exceed 2 m in length.

  • Page 42: Burner Ratings

    High setting Low setting Small burner Town gas 0.19 Liquid Petroleum gas 0.95 0.20 Medium burner Town gas 0.38 Liquid Petroleum gas 0.35 Town gas 0.48 Liquid Petroleum gas 0.40 KM 3014 Town gas 8.30 Total Liquid Petroleum gas 7.25...

  • Page 43: After Sales Service, Data Plate, Guarantee

    Please note that telephone calls may be monitored and recorded to improve our service. When contacting Miele, please quote the model and serial number of your appliance. These are given on the data plate. N.B. A call-out charge will be applied for service visits where the problem could have been resolved as described in these instructions.

  • Page 44: Technical Data

    Technical Data Model No. KM 3014 Cutout Dimensions Width 560-600 mm Depth 490-500 mm Build-in depth 46 mm (Allow additional space below for connection to the gas supply) Unit Dimensions Width 626 mm Depth 526 mm Electrical connection Voltage 220 - 240 V...
  • Page 48 Alteration rights reserved / 2113 M.-Nr. 09 316 120 / 00...

Table of Contents