D-Link DCS-5230 User Manual page 35

Section 3 - Configuration
JPEG Quality:
RTSP URL:
Night Mode:
Enable Night Mode:
Shutter:
Enable Speaker:
Volume:
Enable Microphone:
Volume:
D-Link DCS-5230 User Manual
This sets the JPEG quality of any manual snapshots you take when this video profile is selected.
This setting allows you to set a suffix for your camera's RTSP URL, so you can view your camera's video with
this video profile's settings. For example, if you enter "mpeg4" as your RTSP URL setting and your camera's
IP is 192.160.0.30, you can view your camera's video with these settings through 192.160.0.20/mpeg4 .
Note: Video Profile 3 is always set to MJPEG as the Encode Type to ensure that at least one of the Video
Profiles are viewable by non-IE browsers. Video Profile 4 is for mobile devices only, and always uses MPEG-4
as the Encode Type.
Night mode allows the camera to use a longer shutter speed when the camera is in a low-light environment. If
the camera is in an area where there is sufficient lighting, Night Mode will not affect the video stream.
Check this box to enable Night Mode.
This sets the longest shutter speed Night Mode will use when Night Mode is enabled and the camera is viewing
a low-light scene.
Checking this box will enable you to send audio to an external speaker (not included) attached to the external
speaker jack of your camera. This will allow you to speak with another person through your camera.
This sets the volume level of the external speaker.
Checking this box will enable you to listen to audio picked up by the camera's microphone. This will allow you
to hear what is happening near your camera.
This sets the volume level of the incoming audio.
Note: Higher frame size, frame rate and bit rates will give you better video quality, but they will also require
more network bandwidth. For best viewing results on a mobile phone, we suggest setting the frame rate to 5
fps and bit rate to 20 Kbps.
After making any changes, click the Save Settings button to save your changes, or click the Don't Save
Settings button to discard your changes.
35