Proxyarp_Failed (Id: 05600008); Max_States_Reached (Id: 05600009); Max_States_Reached (Id: 05600010) - D-Link NetDefend DFL-210 Log Reference Manual

2.28.7. proxyarp_failed (ID: 05600008)

Parameters
2.28.7. proxyarp_failed (ID: 05600008)
Default Severity
Log Message
Explanation
Gateway Action
Recommended Action
Revision
Parameters

2.28.8. max_states_reached (ID: 05600009)

Default Severity
Log Message
Explanation
Gateway Action
Recommended Action
Revision
Parameters

2.28.9. max_states_reached (ID: 05600010)

Default Severity
Log Message
Explanation
Gateway Action
Recommended Action
poolname
ERROR
Could not add dynamic ProxyARP route. NATPool <poolname>
It was not possible to dynamically add a core route for the given IP
address.
None
Try to configure a core route with ProxyARP manually.
1
poolname
ip
WARNING
Maximum amount of states <num_states> have been reached for
NATPool <poolname>. Replacing lingering state <replacedip>
The maximum configured number of states for this NAT Pool have
been reached. NATPool subsystem will try to replace the oldest
lingering state.
replace_lingering
Increase the MAXSTATES variable for this NATPool if more
concurrent states are wanted.
1
poolname
num_states
replacedip
WARNING
Maximum amount of states <num_states> have been reached for
NATPool <poolname>. Replacing active state <replacedip>
The maximum configured number of states for this NAT Pool have
been reached. NATPool subsystem must replace an active state since
no lingering states exist.
replace_active
Increase the MAXSTATES variable for this NATPool if more
concurrent states are wanted.
335
Chapter 2. Log Message Reference