Assembly and Installation
Connecting the Handset and Headset
1. Using the provided 9-foot coiled handset cord, insert one end into the jack in the bottom of the
handset. Insert the other end into the jack on the back of the phone console labeled with the
handset icon as shown in
2. Optional. Connect your headset to the jack in the back of the phone console labeled with the
headset icon as shown in
the IP 706 or IP 712 phone. For a list of compatible headsets for the IP phones, refer to the
ADTRAN website at www.adtran.com/phones. Once the headset is connected, the headset feature
is ready to use.
Headset Interface Pinout
The pinout for the optional headset is available in
Headset Compatibility
(ADTRAN's Knowledge Base article 3059) for a list of wireless headsets that have
been approved for use with ADTRAN IP 700 Series phones.
Headset Interface Off-Hook Detection
Off-hook detection is achieved by providing battery across the TX+ and TX- pair and monitoring for loop
current. You can simulate off-hook by connecting a 1.5 k resistor across these pins.
16
Figure 3
below. Place the handset on the handset cradle once installed.
Figure 3
below. There are many types of headsets that can be used with
Optional
Headset
Figure 3. Connecting the Handset and Headset
Table 1
Table 1. Headset Interface Pinout
Pin
1
2
3
4
Copyright © 2011 ADTRAN, Inc.
ADTRAN IP 700 Series Phone Administrator Guide
Handset
below. Refer to
ADTRAN IP 700 Phone Wireless
Function
TX-
RX-
RX+
TX+
6AOSAG0001-31A