Table of Contents
Advertisement
2
BASIC OPERATION
Turning power ON
■
Push [
] to turn the power ON.
q
If the transceiver is programmed for a start up password,
w
input the digit codes as directed by your dealer.
• 10-keypad* can be used for password input.
*IC-F1821/D or IC-F2821/D only:
• The keys as below can be used for password input:
The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are the same.
P0
P1
*In this instruction manual, these keys are
from the left, called [P0]/[P1]/[P2]/[P3]/[P4].
KEY
NUMBER
When the "PASSWORD" indication does not clear after in-
e
putting 6 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
9
P2
P3
P4
P0
P1
P2
P3
P4
0
1
2
3
4
5
6
7
8
9
Channel selection
■
Several types of channel selections are available. Methods
may differ according to your system set up.
NON-ZONE TYPE:
Push [CH Up] or [CH Down], or rotate [CH Up/Down] to select
the desired operating channel, in sequence; or, push one of
[MR-CH 1] to [MR-CH 4] keys to select a channel directly.
ZONE TYPE:
Push [Zone] then push [CH Up] or [CH Down], or rotate [Zone
Up/Down] to select the desired zone.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turn-
ing power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call.
Advertisement
Table of Contents
