Call Procedure; Receiving And Transmitting - Icom IF1721/D Instruction Manual

F1700 series vhf/uhf mobile transceiver
Table of Contents

Advertisement

Call procedure

When your system employs tone signaling (excluding CTCSS
and DTCS), the call procedure may be necessary prior to voice
transmission. The tone signalling employed may be a selective
calling system which allows you to call specific station(s) only
and prevent unwanted stations from contacting you.
Select the desired TX code channel, 2/5-tone code, Indi-
q
vidual ID code* or Talkgroup ID code* according to your
System Operator's instructions.
• This may not be necessary depending on programming.
• Refer to pages 11–13 for selection.
*Digital mode operation only.
Push the call key (assigned to one of the dealer programma-
w
ble keys; except for the Digital mode operation) or [PTT].
After transmitting, the remainder of your communication
e
can be carried out in the normal fashion.
Selective calling
Non-selective calling

Receiving and transmitting

Receiving:
Push [
] to turn the power ON.
q
Push [CH Up] or [CH Down], or rotate [CH Up/Down] to
w
select a channel, in sequence.
When receiving a call, adjust the audio output level to a
e
comfortable listening level.
Transmitting:
Wait for the channel to become clear to avoid interference.
Take the microphone off hook.
q
• 2-tone, 5-tone mute may be released. (The 'audible' condition is
selected and BUSY indicator lights green.)
• A priority channel may be selected automatically.
Wait for the channel to become clear.
w
• The channel is busy when BUSY indicator lights green.
Push [CALL] when initiating a call from your side.
e
• Coded audio may be heard from the transceiver, then "
pears.
• This operation may not be necessary depending on your signal-
ing system. Ask your dealer for details.
While pushing and holding [PTT], speak into the micro-
r
phone at your normal voice level.
Release [PTT] to receive.
t
IMPORTANT: To maximize the readability of your signal;
1. Pause briefly after pushing [PTT].
2. Hold the microphone 5 to 10 cm (2 to 4 inches) from
your mouth, then speak into the microphone at a normal
voice level.
2
BASIC OPERATION
" ap-
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

If2721/dIf2821/dIf1821/d

Table of Contents